Map Range

Input

Manual value to map when Input has no connected signal. The Input slider follows the In range.

Moves the manual source value through the mapped output range.

Has no effect while a cable drives the Input socket.

In

Sets one end of the incoming modulation range. This input value becomes the lower Out value.

Sets the source value that maps to the lower Out endpoint.

In

Sets the other end of the incoming modulation range. This input value becomes the upper Out value.

Sets the source value that maps to the upper Out endpoint.

Out

Sets the output value produced at the lower end of the In range.

Sets the output produced at the lower In endpoint.

Out

Sets the output value produced at the upper end of the In range.

Sets the output produced at the upper In endpoint.

Clamp Output

Stops the output at the selected Out limits when the input moves beyond the In range.

When enabled, values beyond the In range stop at the nearest Out endpoint.

Outputs

Result

Signal mapped into the destination range.

Signal	Control

Notes

• The Input control supplies a manual value until a signal is connected.
• When clamp is enabled, the output is constrained to the destination range after remapping.
• The first output connection locks the Out range to its destination domain and unit.
• Compatible fan-out emits direct domain values without a second edge conversion.

Category	Math